Specifications
TH82 Series Reference Manual
50/50
GS ! Select character size
[FORMAT] <1D>H<21>H<n>
[RANGE]
0≦n≦FFH
[FUNCTION] Selects the character size, height and width.
Bit Function Value
0
1
2
3
Character height selection See table 2
4
5
6
7
Character width selection See table 1
Table 1
Character width selection
Table 2
Character height selection
Hex. Width Hex. Height
00H 1(normal) 00H 1 (normal)
10H 2(double-width) 01H 2(double-height)
20H 3 times 02H 3 times
30H 4 times 03H 4 times
40H 5 times 04H 5 times
50H 6 times 05H 6 times
60H 7 times 06H 7 times
70H 8 times 07H 8 times
[DETAILES] *This command is effective for all characters (alphanumeric and Kanji) except for HRI characters.
*If height or width is out of the defined range, this command is ignored.
*In standard mode, the vertical direction is the paper feed direction and the horizontal direction is
the perpendicular direction to the paper feed. Thus, when 90°clockwise rotation mode is selected,
the relationship between vertical and horizontal direction is reversed.
*In page mode, the vertical and horizontal directions are based on the character.
*When the different sizes of characters are on one line, all the characters on the line are aligned at
the baseline.
*The ESC ! command can turn double-width and double-height modes on or off but the last
received command is effective.