Specifications

TH82 Series Reference Manual
33/33
ESC c 3 Select paper sensor to output paper end signals
[FORMAT] <1B>H<63>H<33>H<n>
[RANGE]
0≦n≦255
[FUNCTION] Selects the paper sensor to output paper end signals.
BIT FUNCTION HEX.
Paper roll near end sensor disabled 00 0
Paper roll near end sensor enabled. 01
Paper roll near end sensor disabled 00 1
Paper roll near end sensor enabled. 02
Paper roll end sensor disabled 00 2
Paper roll end sensor enabled. 04
Paper roll end sensor disabled 00 3
Paper roll end sensor enabled. 08
4 Undefined -
5 Undefined -
6 Undefined -
7 Undefined -
*Bit 0 and 1 are valid only on near-end sensor model.
[CAUTION] *This command is effective only with a parallel interface and is ignored with a serial interface.
*It is possible to select multiple sensors to output signals. If multiple sensors are effective, the paper
end signal is output when any of the sensors detects a paper end.
*The paper end signal switching may be delayed depending on the receive buffer state because
sensor is switched when this command is executed.
*If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor which
outputs paper end signals. This function is valid only on model TH-80s.
*If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor which outputs
paper end signals.
*When all the sensors are disabled, the paper end signal always outputs a paper present status.
[DEFAULT] n=1
This command is invalid.