Specifications

TH82 Series Reference Manual
30/30
ESC T Select print direction in page mode
[FORMAT] <1B>H<54>H<n>
[RANGE]
0≦n≦3 、48≦n≦51
[FUNCTION] Selects the print direction and start position in page mode.
n
Print direction Starting position
0,48 Left to right Upper left (A in
the right figure）
1,49 Bottom to top Lower left (B in
the right figure)
2,50 Right to left Lower right (C in
the right figure)
3,51 Top to bottom Upper right (D in
the right figure)
Forward
Print area
[DETAILES] *When the command is selected in standard mode, the printer executes only internal flag operation.
This command does not affect printing in standard mode.
*This command sets the position where data is buffered within the printing area set by ESC W.
* Horizontal or vertical motion units (x or y) of the following commands differ depending on the
starting position of the printing area.
①If the starting position is the upper left or lower right, data is buffered in the direction
perpendicular to the paper feed direction.
Commands using horizontal motion units (x) : ESC SP, ESC $, ESC ╲.
Commands using vertical motion units (y) : ESC 3, ESC J, GS $, GS ╲.
②If the starting position is the upper right or lower left, data is buffered in the paper feed
direction.
Commands using horizontal motion units (x) : ESC 3, ESC J, GS $, GS ╲.
Commands using vertical motion units (y) : ESC SP, ESC $, ESC ╲.
[DEFAULT] n=0
ESC V Turn 90°clockwise rotation mode on/off
[FORMAT] <1B>H<56>H<n>
[RANGE]
0≦n≦1H , 30H≦n≦31H
[FUNCTION] Turns 90°clockwise rotation mode on/off.
*n=0,30H Turns off
*n=1,31H Turns on
[CAUTION] Double-width and double-height commands in 90°rotation mode enlarge characters in the
opposite directions from double-height and double-width commands in normal mode.
[DEFAULT] n=0