Specifications

TH82 Series Reference Manual
25/25
[CAUTION] *An underline is attached to the full character width including right side character spacing, but not
attached to the space set by HT and 90o clockwise rotated character by ESC V.
*When underline mode is turned off by setting the value of n to 0 or 48, the following data is not
underlined and the underline thickness set before the mode is turned off is kept. The default
underline thickness is 1 dot.
*Changing the character size does not affect the current underline thickness.
*This command does not affect Kanji printing.
Ref. FS -, Turn underline mode on/off for Kanji character.
*Underline mode can also be turned on or off by using ESC !, but note that the last received
command is effective. When underline mode is turned off by using ESC – after turned on by ESC !,
underline mode by ESC ! is turned off.
[DEFAULT] n=0
ESC 2 Specify 1/6-inch line spacing
[FORMAT] <1B>H<32>H
[FUNCTION] The line spacing per line is specified by 1/6 inch.
[DEFAULT] *The default setting is 4.125mm (33 dots).
ESC 3 Set line spacing
[FORMAT] <1B>H<33>H<n>
[RANGE]
0≦n≦255
[FUNCTION] *Sets the line spacing to [n x vertical or horizontal motion unit].
*The line spacing can be set independently in standard mode and in page mode.
[DEFAULT] Line spacing equivalent to 1/6 inch.
ESC 4 Set logo pattern data
[FORMAT] <1B>H<34>H<n1><n2> data1 – data720
[RANGE]
1≦n1≦127
1≦n2≦127
[FUNCTION] Sets logo pattern data by this command.
n Function
0,48 Turns off underline mode
1,49 Turns on underline mode of 1-dot thick
2,50 Turns on underline mode of 2-dot thick
This command is invalid.