Specifications

TH82 Series Reference Manual
21/21
2 Drawer open/close signal(connector pin 3) Low High
3 Off/On Online Offline
4 Not used - Fixed to off
5 Undefined
6 Undefined
7 Not used Fixed to off -
n = 2: Offline status
VALUE
BIT Function
0 1
0 Not used Fixed to off -
1 Not used - Fixed to off
2 Printer cover Cover is closed Cover is open
3 Paper FEED button Not feeding Under feeding
4 Not used - Fixed to off
5 Paper-end stop No stop stop
6 Error No error Error
7 Not used Fixed to off -
Bit 5: Printing stops when the paper end sensor detects paper end or the paper near end sensor
(TH80s only) is turned on with ESC C4. (Refer to page 34 for more information.)
At this time, Bit 5 = 1.
n = 3: Error status
VALUE
BIT Function
0 1
0 Not used Fixed to off -
1 Not used - Fixed to off
2 Motor slip No error Error
3 Autocutter No error Error
4 Not used - Fixed to off
5 Unrecoverble error No error Error
6 Auto recoverble error No error Error
7 Not used Fixed to off -
Bit 6: When printing is stopped due to high print head temparature until the print head temparature
drops sufficiently, bit 6 b is on.
n = 4: Paper roll sensor status
VALUE
BIT Function
0 1
0 Not used Fixed to off -
1 Not used - Fixed to off
2 Adequate Near-end
3
Paper roll near-end sensor
(Near-end sensor model only)
Adequate Near-end
4 Not used - Fixed to off
5 Present End
6
Paper roll sensor
Present End
7 Not used Fixed to off -
CAN Cancel print data
[FORMAT] <18>H
[FUNCTION] Deletes all the print data in the current printable area in page mode.
[DETAILES] This command is enabled only in page mode.