Specifications

TH82 Series Reference Manual
14/14
5.3.3 POWER SUPPLY CONNECTOR
The connector is connected the printer to an external power source.
PIN SIGNAL
1 +24V
2 GND
3 NC
SHELL F.G
2
3 1
SHELL
CONNECTOR MODEL:
Printer side: Hosiden TCS7960-532010 or equivalent
User side: Hosiden TCP8927-631100 or equivalent
Hosiden TCP8927-531100 or equivalent
5.3.4 DRAWER KICK-OUT CONNECTOR
The pulse specified by ESC p or DLE DC4 is output to this connector. The HOST can confirm the
status of the input signal by using the DLE EOT, GS a, or GS r commands.
PIN I/O DESCIPTION
1 - Frame ground
2 Output Drawer kick-out drive signal 1
3 Input Drawer open/close signal
4 Output +24 V
5 Output Drawer kick-out signal 2 ※
6 - Signal ground
※Two drawers can be used with a Y-cable that meets the following specifications.
Pin 1: Frame ground --------------------------------------- ------------- Pin1
Pin 2: Drawer kick-out drive signal 1 -------------------------------- Pin2
Pin 3: Drawer open/close signal ---------------------------------------Pin3 Connector of Drawer No.1
Pin 4:+24V ----------------------------------------------------------------Pin4
Pin 5:Drawer kick-out signal 2 ------------------- ------Pin6
Pin 6: Signal ground Pin6 ---------- ----------------------------Pin1
-----------------------Pin2
-----------------Pin3 Connector of Drawer No.2
------------Pin4
--------------------------------------Pin6
1 6 CONNECTIOR MODEL:
Printer side: MOLEX52065-6615 or equivalent
Used side: 6-position 6-contact (RJ12 telephone jack)