Specifications

TH82 Series Reference Manual
13/13
5.2 PAPER SPECIFICATION
Paper Width: 79.5±0.5mm(3.13±0.02”)
Paper roll size: Roll diameter: Maximum 80mm (3.15”)
Take-up paper roll width: 80 +0.5/-1.0mm (3.15+0.02/-0.04”)
Specified paper: Specified thermal roll paper:
NTP080-80
[Original paper: TF50KS-E2C Nippon Paper Industries Co., Ltd.]
Packaged roll paper:
[Original paper: PD160R-N (Oji Paper Mfg. Co., Ltd.)]
In Japan: Nakagawa Manufacturing Co., Ltd.
In U.S.A: Nakagawa Mfg. (U.S.A.) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
*The following paper can be used instead of the paper above:
Original paper: HP220AB1 (Mitsubishi Paper Mills Ltd.)
Paper roll spool diameter: Inside 12 mm (0.47”)
Outside 18 mm (0.71”)
NOTE: The end of the paper roll must be free to come off the spool when finished. It must not
be adhesively attached or attached in another semi-permanent manner.
5.3 INTERFACE SPECIFICATION
5.3.1 RS-232 SERIAL INTERFACE SPECIFICATION
Data transmission: Serial
Synchronization: Asynchronous
Handshaking: DTR/DSR or XON/XOFF control
Signal levels: MARK = -3 to -15V: Logic “1”/OFF
SPACE = +3 to +15V: Logic “0”/ON
Baud rate: 9600, 19200bps
Data word length: 7 or 8 bits
Parity Settings: None, even, odd
Stop bits: 1 or more
Connector (printer side): Female DSUB-25 pin connector
NOTE: *The data word length, baud length, and parity depend on the DIP switch settings. (Refer
to Appendix A DIP SWITCH SETTING.)
5.3.2 SERIAL INTERFACE CONNECTION EXAMPLE
HOST SIDE PRINTER SIDE
(DTE ex.8251) Pin No.
TXD RXD 3
DSR DTR 20
CTS RTS 4
RTS
RXD TXD 2
DTR DSR 6
FG FG 1
SG SG 7