Quick Start Guide

Clover Network, Inc.
415 N Mathilda Ave, Sunnyvale, CA 94085, USA
EU Declaration of Conformity
Hereby, Clover Network, Inc. declares that the radio equipment type,
C403 is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
help.clover.com/eu-compliance
The frequency band and the maximum transmitted power in EU are
listed below:
WWAN
LTE Band3: 22.5 dBm (Conducted)
LTE Band7: 23 dBm (Conducted)
LTE Band20: 22 dBm (Conducted)
WLAN
2400MHz-2483.5MHz: 16.5 dBm (EIRP)
5150MHz-5250MHz: 19.5 dBm(EIRP)
5250MHz-5350MHz: 19.5 dBm(EIRP)
5470MHz-5725MHz: 21.5 dBm(EIRP)
Restrictions in
AT/BE/BG/CZ/DK/EE/FR/DE/IS/IE/IT/EL/ES/CY/LV/LI/LT/LU/HU/MT/NL/NO/
PL/PT/RO/SI/SK/TR/FI/SE/CH/UK/HR. 5150MHz-5250MHz is for indoor
use only.
Caution: Exposure to Radio Frequency Radiation
This product complies with EU requirements regarding restriction of
exposure of persons to radio-frequency energy (RF) emitted by
telecommunication and radio devices as it is designed and manufactured
in such a way as not to exceed the exposure limits indicated by the
European Union Commission. The permitted SAR limit for the general
population is 2.0 W/Kg for body and 4.0 W/Kg for limb. This limit
guarantees an ample safety margin that protects all persons regardless
of age and health condition. SAR is measured with the device at 5mm to
the body and at 0mm to the extremity, while transmitting at the highest
certified output power level in all frequency bands of the device.
The highest SAR level recorded for this model was equal to
body 1.44W/Kg, & limb 2.28 W/Kg.
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, (2) This device must accept any interference received,
including interference that may cause undesired operation.
FCC Part 15 Class B-specific
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC Warning
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to operate the
equipment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The product comply with the FCC portable RF exposure limit set forth for
an uncontrolled environment and are safe for intended operation as
described in this manual. The further RF exposure reduction can be
achieved if the product can be kept as far as possible from the user body
or set the device to lower output power if such function is available.
Innovation, Science and Economic Development Canada (ISED)
statement:
CAN ICES-3 (B)/NMB-3(B)
This device complies with ISED’s licence-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et
(2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage
susceptible de provoquer un fonctionnement indésirable.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use
to reduce the potential for harmful interference to co-channel mobile satellite
systems;
(ii) the worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p.
elevation mask requirement set forth in Section 6.2.2(3) shall be clearly
indicated.
(iii) Users should also be advised that high-power radars are allocated as
primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850
MHz and that these radars could cause interference and/or damage to LE-LAN
devices.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des
instructions précises sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes
canaux;
(ii) les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence
de la p.i.r.e. applicable au masque d’élévation, et énoncée à la section 6.2.2 3),
doivent être clairement indiqués.
(iii) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de
radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils
ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que ces
radars pourraient causer du brouillage et/ou des dommages aux dispositifs
LAN-EL.
Radiation Exposure Statement:
The product complies with the Canada portable RF exposure limit set forth
for an uncontrolled environment and are safe for intended operation as
described in this manual. The further RF exposure reduction can be achieved
if the product can be kept as far as possible from the user body or set the
device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables
RF pour les Etats-Unis et le Canada établies pour un environnement non
contrôlé. Le produit est sûr pour un fonctionnement tel que décrit dans ce
manuel. La réduction aux expositions RF peut être augmentée si l'appareil
peut être conservé aussi loin que possible du corps de l'utilisateur ou que le
dispositif est réglé sur la puissance de sortie la plus faible si une telle fonction
est disponible.
Argentina:
NFC
-3.84 dBuA/m @ 10m
CE max SAR 10g
Body 1.44W/Kg
Limb 2.28 W/Kg
Este producto utiliza para su funcionamiento una fuente de
alimentación, modelo FSP040-RHBN3 marca Clover con las
siguientes características técnicas: Entrada: AC 100-240 V,
50-60 Hz, 1.5 A, Cl. I; Salida: DC 12 V, 3.33 A, que ha sido
certificada para su utilización en el mercado argentino.
Conectar una fuente diferente a la provista podría ocasionar
un incendio o choque eléctrico.
No utilice una fuente diferente a la provista con el equipo.