DVR User Manual

Chapter 3. Quick Setup
8. Enable Recording
Page 50
Step 3. Globally configure all cameras to record by clicking on “All” mark to enable all cameras then set
resolution to desired setting.
Make sure that All is Unchecked.
Set resolution either to 360X240 ~ 720X480
Step 4. Choose fps setting globally and do not exceed base fps. In the picture example is 480fps as base
fps.
Maximum fps cannot exceed 480 fps in this example.
This section will impact total fps for continuous.
This section will impact total fps for event driven.
Step 5. Chose picture quality setting.
Picture Quality setting for continuous
Picture Quality setting for event drive
Step 6. Exit and confirm changes.