INSTRUCTION MANUAL NIGHT-VISION CYCLOPS COLOR CAMERA MODEL HDC255 Copyright © 2007 Clover Electronics U.S.A. All Rights Reserved.
PRECAUTIONS • • • • • • • To avoid electrical shock, do not open the case of this product. Operate this product using only the supplied AC Power supply. Do not overload electrical outlets or extension cords; this can result in fire or electric shock. Keep this product away from strong magnetic fields. Do not expose this product in direct sunlight or strong reflected rays. Refer servicing to qualified personnel only. Do not change or modify this product, the warranty will be voided.
DVR, monitor/TV. Plug the provided AC adapter to the DC jack (red) of the end of 100’ cable. HOW TO ADJUST ANGLE OF VIEW 1. Turn the four screws① with the provided hex-head wrench counter-clockwise to remove the front cover of the camera. 2.
3. T↔W (Tele ↔ Wide)③ Turn this knob clockwise or counter-clockwise to set the focal length. Secure the knob clockwise after setting. 4. ∞↔N④ Turn this knob clockwise or counter-clockwise to set the focus. Secure the knob clockwise after setting. 5. Assemble the front cover⑤ and make sure firmly tighten the four screws to prevent water leakage. Note: ▪ Apply the provided AC adapter only. ▪ The total length of cable must not exceed 200’ including extension cable.
The image on the screen is dark The image on the screen is dim The camera is not working properly, and the surface of the camera case is hot The contrast on the screen is too weak The image on the screen flickers Picture rolls and jumps, scrambled picture Picture smaller than screen between the camera and a monitor Check the brightness control on the monitor Check if the lens is stained.
defect in material or workmanship, we will repair free of charges for 2 years on parts and labor from the date of original purchase. This warranty does not cover modification, abuse, incidental or consequential damages unless the state of owner’s residence specially prohibits limitations on incidental or consequential damages. HOW TO OBTAIN FACTORY SERVICE 1. Original purchaser must fill out a warranty card and mail it to the factory with model number, serial number and the date of purchase. 2.
