User's Manual

ORBH

Connect the controller’s input cord with output supply of transformer.

There are two ways on each set of controller, each way includes four light units. You need to figure out lay out

of your hardscape project first, then place the controller in the right place. Warning: There is a blue tooth

module inside controller box, which connects with smart hub to realize remote or voice control. Please don’t

cover controller box with metal box or put it in case made of metal or cement.

Place the stainless steel mounting bracket between layers of hardscape material.

Drill ⌀6*1'' expansion pipe into wall, use screw driver to fix st4.2*1'' hook into expansion pipe, use hook to hang

up cable before or after connector port and lock the wire. Adjust cable length of each light unit, connect male

connector with female connector of controller,and use screw ring to fasten them. Repeat this step to connect all

light unit with controller. Warning: Please make sure the edge of input wire of light unit is accessible in case that

you need to replace or remove light unit later.

Connect transformer to main power supply.

7) Refer to User Manual and Voice Guideline to set up products.

12inch

Screw

st4.2x1"

Expansion Pipe

ø6x1"

Low Voltage

Bluetooth Controller

Light Unit

Extension Cord Wire Nut

12inch

(x8)

x8+10 x8+10

Cable clamp

st4.2x1"