User's Manual

If you only have a dimmer at hand, set it to highest level only, if light

performance is not good, we strongly advise you to change to a regular

On/Off switch instead.

CBSL11SMBK

DUST PROOF

WET

Pull out live wire, neutral wire and ground wire from junction box, connect live

wire to LIGHT UNIT’ s black wire, connect neutral wire to LIGHT UNIT’s white

wire, connect ground wire to LIGHT UNIT’s bare cooper wire with BB, or fix both

ground wires on mounting bracket’s green screw firmly.

Approach LIGHT UNIT to the MOUNTING BRACKET CC, till LIGHT UNIT’s

center hole go through screw stem , adjust stem’s length and tighten it with

hex nut one, fix LIGHT UNIT with another hex nut two.

Use Philips screwdriver to fix MOUNTING BRACKET CC on junction box

( junction box excluded) with SCREW AA.

MOUNTING BRACKET

USER MANUAL & VOICE CONTROL GUIDE

PAGE 1
CBSL11SMBK MOUNTING BRACKET WET DD DUST PROOF USER MANUAL & VOICE CONTROL GUIDE or 2 Use Philips screwdriver to fix MOUNTING BRACKET CC on junction box ( junction box excluded) with SCREW AA. or 3 If you only have a dimmer at hand, set it to highest level only, if light performance is not good, we strongly advise you to change to a regular On/Off switch instead.
PAGE 2
CBSL11SMBK or 5 5 Apply silicone caulking adhesive (not included) completely around the perimeter of the fixture where the back meets the mounting surface to prevent water from seeping into the junction box. or 5 5 6 Installation is completed, please go ahead to USER MANUAL & VOICE CONTROL GUIDE EE to complete setting.
PAGE 3
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.