User Manual

The battery inside this product is a sealed lead-acid battery. It is required by law to

be removed and recycled or disposed of properly. While there are federal regulations

thatmustbecompliedwiththroughouttheUnitedStates,yourindividualstateorlocal

governments may have additional regulations to be followed.

When the battery in this product is in need of replacement, remove it according to the

instructions provided below and take it to your local recycling center for proper recycling

or disposal. If you don’t have a local recycling center that handles sealed lead-acid

batteries, contact your local environmental agency for instructions.

Removal instructions:

Beginbymakingsurethatbothclampsaresecurelyplacedinapositionthatensures

they will not come into contact with each other.

1.Ensuretheunit’sON/OFFswitchisintheOFFposition.

2. LaytheJump-N-Carrydownonitsfront.Onthebackoftheunit,locatethe

screws that hold the case together (including screws located in the cable

management tracks).

3. Remove the screws, then lift off the back half of the case, lifting first from the

bottom.

4. Onthetopofthebatteryaretwoterminals,eachwithwiresconnectedtothem.

Disconnect these wires from the battery by removing the bolts that hold them to

the battery terminals. To prevent accidental arcing, be careful not to touch both

battery terminals with the tools being used to remove the bolts.

5. Liftthebatteryoutofthefronthalfofthecase.

Battery Replacement and Disposal

This unit contains a sealed non-spillable lead-acid battery.

This battery must be recycled. Consult your state or local

government concerning regulations for proper disposal.