User Manual

Features
• TheJump-N-Carry provides plenty of power for starting vehicles – more than
enoughtostartmostcars,trucks,SUVsandlightdutycommercialvehicles.
• Theunitcontainsthelatesttechnologywithits12Voltsealed,non-spillable
battery and may be stored in any position.
• Theunitfeaturesatestswitchandbatterystatusindicationdisplay,which
provides an indication of the battery’s state of charge.
• TheunitfeaturesamasterON/OFFswitch.TheunitshouldbekeptintheOFF
position at all times when it is not in use.
• Theunitfeaturesextra-longcablereachtoallowsafe,easypositioningwhile
jump starting. Always re-wrap cables and re-holster the clamps after each use.
• Theunitwillpowermost12Vdcaccessoriesequippedwithamale12Voltplug.
The DC outlet features automatic overload protection.
• TheunitwillprovideUSBpowertosmallelectronics,with1.1Aand2.1Aoutput
options available.
• TheunitfeaturesahighintensityLEDlighttoassistwhenjumpstartinginthe
dark or at other times when additional light is needed.
Recharging
Note: Upon initial purchase, charge your Jump-N-Carry until the display reads FUL.
Recharge the Jump-N-Carry using a household extension cord connected to the built-in
charger in the back of the unit.
1. Connect the female end of the extension cord to the charger plug on the back of
the unit. The charger plug has two blades and resembles a standard household
plugthatwouldfitintoa120Vacwallreceptacle.
2. ConnectthemaleendoftheextensioncordtotheACoutlet.
3.ChargeuntilthedispayreadsFUL.
Note: The unit can remain connected to AC power indefinitely without adverse
consequences. The charging system is fully automatic and will only consume
power as need to maintain the onboard battery.
Battery Status Indication
Pressandholdthe“V”(VoltageStatus)Buttontoshowthebatterystatusonthedisplay.
The message seen on the display corresponds to the battery’s state of charge:
 • Ifthebattery’svoltageislessthan12.4V,thedisplaywillflashthevoltageand
thenshowCHGcontinuously,indicatingtheunitshouldbechargedimmediately.
 • Ifthebattery’svoltageisbetween12.4-12.8V,thedisplaywillshowthebattery’s
voltageandthenflashCHGthreetimes,indicatingtheunitisinneedofcharge.
 • Ifthebattery’svoltageisabove12.8V,thedisplaywillalternatelyflashthe
battery’svoltageandFUL,indicatingthattheunitisfullycharged.