Instruction manual

Features
• TheJump-N-Carry provides plenty of power for starting vehicles – more than
enough to start most cars, light trucks, watercraft, implements and more.
• TheJump-N-Carry will power most 12 Vdc accessories equipped with a male
12 Volt plug. The DC outlet features automatic overload protection.
• Theunitfeaturesatestswitchandbatterystatusgauge,whichprovidesan
approximate indication of the battery’s state of charge.
• TheJump-N-Carry features convenient side-mounted holsters with cable tracks
for easy cable and clamp management. Always re-wrap cables and re-holster the
clamps after each use.
• TheJump-N-Carry contains the latest technology with its twin sealed,
non-spillable battery and may be stored in any position.
Recharging
Note: Upon initial purchase, charge your Jump-N-Carry for a minimum of 24 hours.
There are two ways to charge your Jump-N-Carry. The recommended method is
recharging using AC power, where the provided 2-pin extension cord is connected to
the built-in charger. An alternative method is through the DC power outlet using the
provided 12 Volt Male-Male Extension Cord. In some cases, care must be taken not to
overcharge the Jump-N-Carry, as noted.
Charging using the built-in charger (recommended method). With this method, the
provided 2-pin extension cord is connected to the Jump-N-Carry through the built-in
charger located on the front of the unit. Only use the provided extension cord when
charging the unit.
1. Connect the female end of the 2-pin extension
cord to the charger plug on the front of the unit.
The charger plug is located in a recessed cavity
on the upper left of the front of the unit.
2. Connect the male end to the extension cord to the
AC outlet.
3. Charge as noted in the following table, using the
battery status gauge as a guide as to whether
the unit has reached full charge. This charging
method is fully automatic, eliminating any risk of
overcharging.Usingthismethod,theunitmaybe
connected to the AC outlet continuously, with no
adverse consequences.
Battery Status Gauge
Press the red switch to momentarily activate the battery status gauge. The gauge is an
approximate indicator of the battery’s state of charge. When fully charged in the 12-volt
mode and disconnected from charging power, the gauge should read from 13-13.5 Volts.