Instructions / Assembly

6
NOTE: IF YOU NEED TO DISCONNECT THE
SPRING PLUG FROM THE WINDING UNIT,
TAKE EXTRA CARE. To remove the spring
from the winding unit, two small at-headed
screwdrivers will be required. Two tabs must
be released, but only one tab is accessible at
a time. Depress the accessible tab with a small
screwdriver. To prevent the tab from relocking,
place a second screwdriver between the
spring plug and winding unit near the released
tab. Wind the winding unit until the other tab
can be accessed. Depress the second tab with
a small screwdriver. Make sure both tabs have
been released. Gently pull the spring from the
winding unit.
After all the components are on the tube, the
spring plug should be inserted into the winding
unit. Ensure that the spring plug and the
winding unit have the same color code before
snapping them together. Line up both ears on
the spring plug with the two slots in the winding
unit and push them together (Fig. 8, views B, C
and D). Slide the components toward the center
of the tube to expose 12" of each end of the tube.
WARNING
Make sure that both ears of the spring plug are
fully intact and engaged into the winding unit
slots. Be certain that both of the tabs in the
winding unit slot engage with the spring plug
and that the connection between the spring
plug and the winding unit is secure before
proceeding.
NOTE: STENCILING ON SPRING MATCHES
THE LABEL ON THE WINDING UNIT “LEFT”
OR “RIGHT”
VIEW A
LEFT
RIGHT
VIEW B
VIEW C
VIEW D
Fig. 8
Winding Unit
Slots & Tabs
Spring
Tabs
(Press Here
to Remove)
Spring
Plug
Winding
Unit
Winding Unit Label
Left Side (Green)
Winding Unit
Slots & Tabs
Plug
LEFT SIDE SHOWN
BEFORE INSERTION
Plug
Winding Unit Label
Right Side (Orange)
LEFT SIDE SHOWN
AFTER INSERTION