Instructions / Assembly

Step 9

Install the tube retainer as shown in Fig. 14.

Attach the tube retainer to the EZ-SET

Torsion

Spring System bracket with a 3/8" - 16 x 3/4"

carriage bolt. Be sure to position the carriage bolt

and ange nut as shown in Fig. 14. Be sure to

install a tube retainer on both the left and right

sides of the door.

NOTE: Tube retainer and spring may be

periodically lubricated with a light household

oil if squeaking occurs.

WARNING

To avoid personal injury, do not rest hand or

any other part of your body on the spring or

any part of the EZ-SET Torsion Spring System

while tensioning or untensioning the spring.

During winding, operate the drill at HALF

SPEED until the required number of winds

is reached. If additional winding is required

or the system has to be completely unwound,

wait AT LEAST FIVE MINUTES between

consecutive winds/unwinds. If for any reason

the unit begins to resist wind, STOP winding

at once and wait AT LEAST FIVE MINUTES

before continuing. Failure to follow these

instructions may result in damage to the

unit, the rapid release of spring energy or

personal injury.

To remove ALL tension from the spring,

unwind (drill in reverse/counterclockwise)

until the spring paint stripe is a single straight

line and the lift cables are slack.

Adjust the number of spring winds only when

the door is completely closed.

Fig. 14

Tube

Retainer

Carriage

Bolt and

Flange Nut

Bracket

LEFT SIDE SHOWN