Instructions / Assembly

6
* More struts may be required in high windload areas. (While not representative of any one model, the quantities below can be used as a guide.
In some instances, extra screws/bolts are provided in the event of strip-out or loss of parts.)
MATERIALS NEEDED (NOT INCLUDED)
General
 (1) Can of Clopay
®
Pro-Lube
 (24) 10d 3" common nails
 Stop molding
 Wood shims
 Wood block
 Rope
Rear Track Hanger Specific
 (1) Rear Track Hanger Kit or material to make track hanger
 1-1/4" × 1-1/4" minimum 13 ga. (3/32") minimum thickness
punched angle
 (10) 3/8" × 1" bolts and nuts
 (6) 5/16" × 1-1/2" lag screws
TOOLS NEEDED (NOT INCLUDED)
 Work gloves
 Safety goggles
 C-clamps or locking pliers
 Hammer
 Flathead screwdriver
 Measuring tape
 Level
 Socket wrench set
 7/16" and 9/16"
box wrenches
 Drill, 1/4", 3/16" and
3/8" drill bits, 7/16" and 9/16"
drive bits
 Stepladder
 Sawhorses (with non-abrasive
carpet or other soft material on
top surface) or other supports
for placing section on while
assembling
 Hacksaw
 Wood saw
 Angle square
 Additional tools may be
required for spring installation
ADDITIONAL MATERIALS NEEDED (NOT INCLUDED)