Instructions / Assembly

Pull Rope

Fig. 13-A

Fig. 12-A

#14 x 5/8" Sheet Metal Screw or 1/4" x 1" Lag Screw

If a lock is included with door, follow appropriate instructions below.

Exterior Keyed Lock:

■

If door has an exterior keyed lock, complete installation of lock at this

time. Follow instructions provided with lock hardware.

Interior Slide Lock:

■

Use track as a guide to achieve proper alignment.

■

Position slide bolt against top of one of rectangular engaging slots in

vertical track.

NOTE: It may be necessary to knock out slug in vertical track to open

slot for lock engagement. Remove slug by striking with a hammer from

outside of track.

■

Install inside slide bolt on the end stile of second section.

Use (4) #14 × 5/8" hex head sheet metal screws (steel doors)

or (4) 1/4" × 1" lag screws (Fig. 12-A).

NOTE: 3/16" holes may need predrilled before installing screws.

IMPORTANT: If door is going to be equipped with an automatic garage

door opener, make sure that door is always unlocked when opener is

being used. This will avoid damage to door.

Fig. 13-A

Fig. 12-A

STEP 12 - INSTALL LOCK (IF INCLUDED)

STEP 13 - INSTALL PULL ROPE (MANUALLY OPERATED DOORS ONLY)

STEP 14 - INSTALL SPRINGS

NOTE: Rope is only intended for use on manually operated doors.

DO NOT install pull rope if using an automatic garage door opener.

Step 13-1: Install Pull Rope for Manually Operated Doors

■

Install the pull rope by attaching to roller shaft in bottom bracket of door

(Fig. 13-A).

Step 14-1: Install Springs

■

Proceed to springing instructions that came with spring hardware.