Instructions / Assembly

15
#2 Hinge
#1 Hinge
Bottom Edge
End Stile
#14 x 5/8" Sheet
Metal Screws
Fig. 9-C
Step 9A-3: Prepare Second (Lock) Section
NOTE: If door is predrilled for a lock, this section will be the one with
holes in the center of panel face.
■
Place Second Section face down on covered sawhorses.
■
Attach a #2 hinge to each end at top edge using (2) #14 × 5/8" sheet
metal screws. Attach a #1 hinge to all other prepunched holes using (2)
#14 × 5/8" sheet metal screws (Fig. 9A-C).
Step 9A-4: Keyed Lock/Lift Handle Installation
■
If you wish to install a keyed lock, begin lock installation now according
to supplemental instructions included with lock hardware.
■
If door did not come with a keyed lock, install lift handle (Fig. 8A-B).
! CAUTION
Take care not to bend or twist sections with glass as this may cause
glass to break, which may result in personal injury.
Step 9A-5: Place and Secure Second (Lock) Section
■
Place Second Section in opening on top of First Section.
■
Drive a 10d 3" nail in jambs at each section end. Bend over edge to hold
section in place.
■
Attach hinges from top of First Section to bottom of Second Section using
(2) #14 × 5/8" sheet metal screws for each hinge (Fig. 9A-D).
Step 9A-6: Prepare Next (Third) Section
Third Section has the general safety label applied (Fig. 9A-D).
■
Place section face down on covered sawhorses.
■
Attach a #3 hinge to each end at top edge using (2) #14 × 5/8" sheet
metal screws for each hinge. Attach a #1 hinge to all other prepunched
holes using (2) #14 × 5/8" sheet metal screws (Fig. 9A-E).
NOTE: If door has more than 1 strut, consult Table 7-A or 7-C. Attach
using 1/4" × 3/4" self-tapping screws (Fig. 9A-E). When predrilled
holes do not line up with hinge, drill (2) 3/16" pilot holes through strut,
hinge and door at each location or use impact wrench with 7/16"
socket and self-tapping screws.
Step 9A-7: Place and Secure Next (Third) Section
■
Place section in opening on top of previously installed section.
■
Drive a 10d 3" nail in jambs at each section end. Bend over edge to hold
section in place.
■
Attach hinges from top of previous section to bottom of this section using
(2) #14 × 5/8" sheet metal screws for each hinge (Fig. 9A-E).
NOTE: If you have two sections left, repeat STEP 9A-6 to 9A-7 using
#4 hinges on the end of the top edge and #1 hinges to all other stiles
along the top edge.
! WARNING
DO NOT install top section unless you are able to immediately continue
through to STEP 9A-10 installing vertical track as this may cause
sections to fall.
! WARNING
DO NOT install top section if there are high wind conditions as this may
cause sections to fall. Failure to follow these warnings could result in
serious injury, death or property damage.
#3 Hinge
End Stile
Bottom Edge
#1 Hinge
#14 x 5/8" Sheet
Metal Screws
Fig. 9-E
Safety
Label
Fig. 9-D
Fig. 9A-D
Fig. 9A-E
Fig. 9A-C