Instructions / Assembly

14
NOTE: For Composite Doors proceed to STEP 9B.
Step 9A-1: Place and Secure First (Bottom) Section
■
Place First Section in opening against stop molding and center it from
side to side.
■
Place a level on section. If necessary, use wood shim under one end to
make section level (Fig. 9A-A).
■
Once section is level, remove level and drive a 10d 3" nail in jambs at
each section end. Bend over edge to hold section in place (Fig. 9A-B).
Step 9A-2: Determine Stacking Order for Remaining Sections
Using Table 9A-A or 9A-B Below
NOTE: If a lock assembly was ordered with door, holes for lock may be
predrilled. Lock templates are included in lock instructions for doors
without predrilled holes.
Table 9A-A:
SECTION ORDER FOR INSULATED STEEL GARAGE DOORS
Door
Height
1st
(Bottom)
Section
2nd
(Lock)
Section
3rd
Section*
4th
Section
5th
Section
6'0" 18" 18" 18" 18" –
6'3" 18" 18" 18" 21" –
6'6" 21" 18" 18" 21" –
6'9" 21" 21" 18" 21" –
7'0" 21" 21" 21" 21" –
7'6" 18" 18" 18" 18" 18"
7'9" 18" 18" 18" 18" 21"
8'0" 21" 18" 18" 18" 21"
* Section with general safety label.
Table 9A-B:
SECTION ORDER FOR STEEL CARRIAGE HOUSE GARAGE DOORS
Door
Height
1st
(Bottom)
Section
2nd
(Lock)
Section
3rd
Section*
4th
Section
6'0" 24" 24" 24" –
6'3" 18" 18" 18" 21"
6'6" 21" 18" 18" 21"
6'9" 21" 21" 18" 21"
7'0" 21" 21" 21" 21"
7'3" 21" 21" 21" 24"
7'6" 24" 21" 21" 24"
7'9" 24" 24" 21" 24"
8'0" 24" 24" 24" 24"
* Section with general safety label.
Fig. 9-B
Fig. 9-A
Stop Molding
Fig. 9A-A
Fig. 9A-B
STEP 9 - INSTALL DOOR SECTIONS
STEP 9A: FOR INSULATED GARAGE DOORS & STEEL CARRIAGE HOUSE GARAGE DOORS