Instructions / Assembly

13
Step 8C-1:
■
Use supplemental templates provided in handle bag to determine handle
configuration for your door size.
Step 8C-2:
■
Find the center of the distance between embosses on the front of the
section.
■
Use template included with handle to line up the center lines and the
bottom section.
■
Drill two 1/2" holes where indicated through the front skin of the section
and insulation, but STOP BEFORE drilling through the back skin.
Step 8C-3:
■
Flip section over and drill two 5/16" holes through the back skin.
Step 8C-4:
■
Slide the black head 1/4" carriage bolt through horizontal spade handle,
handle spacer, front of the section, back of the section and roll grip
handle.
■
Secure with 1/4" flange nuts. (Fig. 8C-A or Fig. 8C-B)
■
Repeat Steps 8C-2 through 8C-4 for second bottom handle
(if applicable).
■
Second section (to be installed at completion of STEP 9A-4.
(Not required on doors with outside keyed lock.)
Step 8C-5:
■
Use back of the template to find your door configuration.
■
Using the template, drill the holes in your second section.
Step 8C-6:
■
Find the center of the distance between embosses and the middle of the
section height on the front of the section.
■
Use template included with handle to line up the center lines and the
bottom section.
■
Drill the indicated 1/2" holes through the section and insulation.
Step 8C-7: Two Outside Spade Handles
For one handle, skip to STEP 8C-8.
■
Line up holes in handle backer plate with holes drilled in previous step.
■
Attach handle backer plate to back of door with (2) #14 × 5/8" sheet
metal screws through inside roll grip handle and into the inside skin
(Fig. 8C-A).
■
Slide (2) 1/4" black head carriage bolts through the vertical spade handle,
the handle spacers, door section and through the backer plate.
■
Secure on the inside with 1/4" flange nuts. Do this for each handle
(Fig. 8C-A). Skip to STEP 9.
Step 8C-8: One Outside Spade Handle
■
Slide (2) 1/4" black head carriage bolts through vertical handle, handle
spacers, door section and through backer plate.
■
The top carriage bolt should also go through the top hole of the roll grip
handle.
■
Attach bottom of roll grip handle with a #14 × 5/8" sheet metal screw
into the backer plate (Fig. 8C-B).
Step 8C-9:
■
Repeat STEP 8C-6 through 8B-8 for second handle set (if applicable).
6
5
3
2
4
6
7
5
8
1
1
3
4
6
5
5
7
5
6
8
4
1
3
4
2
3
Fig. 8C-A
Fig. 8C-B
STEP 8 - INSTALL LIFT HANDLES
STEP 8C: FOR STEEL CARRIAGE HOUSE GARAGE DOORS