Instructions / Assembly

12
5-1/2" (Composite Overlay Doors)
5-1/4" (Composite Overlay Faux Wood Doors)
5-1/2"
Inside Handle
1/4" Hex Flange Nut
Outside Handle
Spacer
1/4" - 20 x 2-1/4"
Hex Head Bolt
Spacer
Outside Handle
1/4" Hex Flange Nut
1/4"- 20 x 2 -1/4"
Hex Head Bolt
Inside
Handle
Step 8B-1:
■
Center horizontal handle on outside of bottom door section 2" from
bottom of section. Using handle as a template, mark the holes to be
drilled (Fig. 8B-A).
Step 8B-2:
■
Drill two 1/4" holes straight through the door at the marks.
■
From outside, enlarge the two 1/4" holes using a 3/8" drill, being careful
not to drill through the inside skin of the door.
■
Remove excess foam from the 3/8" holes.
Step 8B-3:
■
Insert 3/8" diameter spacer(s) into each hole from the outside of the door.
IMPORTANT: Failure to install spacers may result in damage to the
door.
Step 8B-4:
■
Attach the black handle (outside) and the steel roll grip handle (inside) to
the door using two 1/4" black painted hex head bolts, and two 1/4" hex
nuts (Fig. 8B-B).
Step 8B-5:
■
Position two vertical handles on the second section. Using handles as a
template, mark holes to be drilled. The lower hole on each vertical handle
must lie between 20" and 30" vertically from the holes on the bottom
handle and be centered 5-1/2" horizontally from each other.
■
Be sure holes on both vertical handles line exactly with holes on the
bottom horizontal handle. No hole may be closer than 2" to the top or
bottom of the section (Fig. 8B-C).
Step 8B-6:
■
Drill four 1/4" holes straight through the door at the marks.
■
From the outside, enlarge the four 1/4" holes using a 3/8" drill, being
careful not to drill through the inside skin of the door.
■
Remove any excess foam from the 3/8" holes.
Step 8B-7:
■
Insert 3/8" diameter spacer(s) into each hole from the outside of the door.
IMPORTANT: Failure to install spacers may result in damage to the
door.
Step 8B-8:
■
Attach each vertical handle (outside) and one steel horizontal roll grip
handle (inside) to the door using (2)1/4" black painted hex head bolts, and
(2) 1/4" hex nuts.
■
Use hex head bolts and hex nuts to fasten the vertical handles to the door
through the remaining holes.
■
Inside handle may be matched with either set of holes so long as it is no
closer than 4" to the top or bottom of the section (Fig. 8B-C).
Fig. 8B-A
Fig. 8B-B
Fig. 8B-C
STEP 8 - INSTALL LIFT HANDLES
STEP 8B: FOR COMPOSITE DOORS