Instructions / Assembly

18
Required Materials
(1) operator reinforcement bracket (2) 1/4" × 3/4" self-tapping screws
Required Materials
(1) operator reinforcement bracket (2) 1/4" × 3/4" self-tapping screws
Required Materials
(2) operator reinforcement bracket (2) 1/4" lock washers
(2) 2" pieces of 1-1/4"
×
1-1/4"
punched angle
(2) 1/4" nuts
(2) 1/4" × 1" bolts (4) 1/4" × 3/4" self-tapping screws
IMPORTANT: To avoid damage to door, you MUST reinforce top section
of door in order to provide a mounting point for opener to be attached.
Refer to STEP 10A – Reinforcing the Top Section.
Failure to reinforce door as illustrated will void door warranty.
IMPORTANT: When installing an automatic garage door operator, follow
manufacturer’s installation and safety instructions carefully.
! WARNING
To avoid risk of strangulation or personal injury, if door has a pull rope,
you must remove pull rope when you install an automatic garage door
opener.
! CAUTION
If you have installed a door lock, unlock or remove at this time.
Failure to do so may cause damage to the door and void the warranty.
Step 10B: Remove Pull Rope and Lock
■
Figures 10B-A through 10B-C show installation of operator reinforcement
corresponding to a specific door width.
■
At locations where the bracket is attached to the hinge, the hinge screws
must be removed, the bracket installed and the hinge screws then
replaced.
Fig. 10B-A Fig. 10B-B
Fig. 10B-C
STEP 10 - REINFORCE THE TOP SECTION FOR GARAGE DOOR OPENER
STEP 10B: FOR COMPOSITE OVERLAY FAUX WOOD DOORS