Replacement Part List

P01-R01-0704
STEP 10 - Reinforcing the Top Section
for Opener
To avoid damage to your door, you must reinforce the top
section of the door in order to provide a mounting point for the
opener to be attached. You will need one (1) or three (3) pieces
of 1-1/4" x 1-1/4" minimum punched angle at least 13 gauge or
3/32" thick from your local hardware or building supply store.
Figures 10-A to 10-D show how punched angle is to be afxed
to door. Angle iron may need to be trimmed depending on door
section height and distance between center stiles.
Do NOT install the bracket supplied with the opener.
Failure to reinforce the door, as illustrated, will void
your warranty.
Required Materials:
(1) 18" or 21" length of angle iron,
(2) #14 x 5/8" sheet metal screws,
and (2) 1/4" x 3/4" self tapping screws.
18'' or 21''
Punched Angle -
Two 18'' or 21'' pieces
(measure top section height).
Strut
Notch Cut
on Vertical Angle
5''
15'0'' up to 15'10'' &
19'0'' up to 20'0'' Wide Doors
with Strut
Punched Angle for
Operator Draw Bar
Attachment
18'' or 21''
Strut
Notch Cut
on Vertical Angle
5''
16'0'' up to 18'0'' Wide
Doors with Strut
Required materials:
(2) 18” or 21” lengths of angle iron, (2) ¼’’x1’’ bolts,
(2) ¼’’ lock washers, (2) ¼’’ nuts, (4) #14 x 5/8" sheet metal
screws, and (4) 1/4" x 3/4" self tapping screws.
NOTE: An opener bracket kit specically designed for
opener attachment may be included or may be purchased as
an option (silver galvanized or white powder coated).
Instructions are provided with the kit.
NOTE: Operator may be attached up to 2 feet off center.
(Doors with Torsion Springs Only)
FIG. 10-B
FIG. 10-D
Required materials:
(2) 18” or 21” and (1) 27” or 50” length of angle iron
(2) ¼’’x1’’ bolts, (2) ¼’’ lock washers, (2) ¼’’ nuts,
(8) #14 x 5/8" sheet metal screws.
8'0'' up to 9'0'' Wide Doors
Vertical Punched Angle
18" or 21" Long
Punched Angle -
One 27'' long piece
(12' wide doors require one 50'' long piece) and
two 18'' or 21'' pieces (measure top section height).
18'' or 21''
Notch Cut
on Vertical Angle
2''
Punched Angle
for Operator Draw
Bar Attachment
18'' or 21''
18'' or 21''
27'' or 50''
10'0'' up to 14'10'' Wide Doors
Required materials:
(1) 18" or 21" length of angle iron, and
(4) #14 x 5/8" sheet metal screws.
FIG. 10-A
FIG. 10-C
14