Instruction Manual

Set the time and calendar manually
Since the unit works on receiving the time
radio signal, there may be locations that the
signal is weak and cannot be properly
received. Under such circumstance, the radio
signal mark will
disappear to indicate that
reception failed. Try to rotate the unit or
place it in other location to achieve
better
reception and re-start reception again. If the
radio signal cannot be received, time should
be set manually.
To set time and calendar, press and hold the
SET/RECEIVE BUTTON until the year
digits flash (
"setting year" will be
announced). Press the UP or DOWN
BUTTON to adjust.
Press SET/RECEIVE BUTTON once. The
time zone mark will flash (
"setting time
zone" will be announced). Set to "P"
(PACIFIC) / "M" (MOUNTAIN) / "C"
(CENTRAL) / "E" (EASTERN) time zone
by pushing the UP or
DOWN BUTTON.
Press SET/RECEIVE BUTTON on9e. The
hour and minute digits flash (
"setting time"
will be announced). Press the UP or DOWN
BUTTON to adjust. Each push of the UP or
DOWN BUTTON will adjust one minute
and the hour will be changed when 00
minute is run through.
Press SET/RECEIVE BUTTON once will end
the setting mode (
"setting complete" will be
announced).
During setting, press and hold the UP or
DOWN BUTTON
and the corresponding
digits
will fast advance.
Note: when setting year, date, time zone or
time, the corresponding digits will be
announced.
e.g. setting year to 2010: ''year two
thousand and ten" will be announced
setting date to January 10
th
(Saturday):
"Saturday, January tenth" will be
announced.
Setting time zone to "P" (Pacific):
''pacific standard time" or ''pacific
daylight saving time-"
will be
announced.
setting time to PM 2:30: "half past two
PM" will be announced.
Set the alarm time
To start alarm time setting, press any one of
the UP or DOWN BUTTON once. The alarm
time
digits will flash (
"alarm set'' will be
announced). Another push of the UP or
DOWN BUTTON will set the alarm minute,
while the hour will be changed when "00"
minute is run through. Press and
. hold the UP or DOWN BUTTON and the digit
will fast advance. To end the alarm setting
mode, just leave the unit (buttons) untouched
for about 5 seconds.
Alarm on/off and hourly announcement
BUTTON and the alarm will be stopped and
rest1;me after 5 minutes. To stop the alarm,
place the ALARM SWITCH to "OFF" or
"(<<[) " (HOURLY ANNOUNCEMENT)
position.