Instruction Manual

ManualsBrandsClocks ManualsAlarm ClockClocks 101077 Atomic Talking Alarm Clock

Table Of Contents

Atomic Talking

Alarm Clock

101077

INSTRUCTION MANUAL

Features:

■ Full range human voice time and date

announcement, with smooth and natural

sound quality.

■ Atomic Clock. Change to standard time

daylight time automatically.

■

Display time with running second,

month, date, day-of-week and alarm

time.

■

Hourly time announcement between

8AM to 10PM inclusively. User can

select to tum on or off the hourly

announcement.

■ Extra long 5 minute alarm sound, with

beep tone and current time announce.

■ 5 minute snooze function.

■

Soft and bright backlight.

■

high and low announcement

volume

selection.

■

Button lock function.

The radio controlled clock works on the

principle of receiving time signals from the

WWVB time signal broadcasting station.

time signal can be received, the clock will

be synchronized with the time of the US

Atomic Clock and change to standard time

/ daylight saving time

automatically. To enhance good receiving

condition, avoid placing the unit near

television sets, metal surfaces, computers

or electric devices, as these devices will

interfere with the reception of radio signals.

Summary of content (4 pages)

PAGE 1
Atomic Talking Alarm Clock 101077 Features: ■ Full range human voice time and date announcement, with smooth and natural sound quality. ■ Atomic Clock. Change to standard time / daylight time automatically. ■ Display time with running second, month, date, day-of-week and alarm time. ■ Hourly time announcement between 8AM to 10PM inclusively. User can select to tum on or off the hourly announcement. ■ Extra long 5 minute alarm sound, with beep tone and current time announce.
PAGE 2
Battery installation and replacement The unit uses 2 AAA batteries. To install or replace batteries, please slide open the batterycompartment (located at the bottom of the unit) by following the direction of the arrow mark. Insert the batteries by following the polarity marked and press the RESET BUTTON once. Close the battery cover and the unit is ready for use now. When the display (or backlight) is dim or the sound quality drops, it means the battery power is not enough.
PAGE 3
Set the time and calendar manually Since the unit works on receiving the time radio signal, there may be locations that the signal is weak and cannot be properly received. Under such circumstance, the radio signal mark will disappear to indicate that reception failed. Try to rotate the unit or place it in other location to achieve better reception and re-start reception again. If the radio signal cannot be received, time should be set manually.
PAGE 4
When the ALARM SWITCH is placed to "((c[)l" (HOURLY ANNOUNCEMENT) position ("announcement on" will be announced), the unit will announce the time at every hour during 8 AM to 10 PM. Outside this range hourly announcement is automatically shut off To deactivate both the alarm function and the hourly announcement function, place the ALARM SWITCH to "OFF" position. Select the announcement volume To select the high volume level, set the VOL (VOLUME) SWITCH to "HI" position.