User Guide

12
Setup Areas
Whilst in engineers mode, there are 3 editable setup areas. Y ou will
always enter setup area 1 first. The green V olume In LED bar will flash
to indicat e which setup area you are in.
Setup Area 1:
Maximum V olume Adjustment (LED 1 flashes)
Increase maximum
staff volume lev el
Decrease maximum
staff volume lev el
Increase maximum
customer volume level
Decrease maximum
customer volume level
Setup Area 2:
Ducking Adjustment (LED 2 flashes)
Increase
ducking level
Decrease
ducking
level
Ducking on
(Vol Out LED 1 illuminat es)
Ducking off
(Vol Out LED 1 turns off)
Setup Area 3:
Hearing Loop Drive Adjustment (LED 3 flashes)
Increase driv e
Decrease driv e
LEDs illuminate t o
display loop driv e
v olt age
The drive level should be adjusted so the red LED 8 is illuminated only when
ther e ar e pe aks in the speech v olume.
If the amplifier does not hav e a loop att ached, y ou can turn off the r ed
loop
fault LED 8 by adjusting the drive down to off.
Please note:
• If the amplifier det ects an error in its settings memory it will r est or e
itself t o f act ory def ault settings.