Assembly Instructions
installation instructions
Tools Required
• 1.25" #8 galvanized wafe head screw
• Screw gun
• 2 to 4 foot level
• Small torpedo level
• Slap stapler (for external applications to fasten paper to wall)
• Chop saw or other cutting tool
How to cut stone (if needed)
ClipStone is easily cut both horizontally and vertically
with a chop saw. PLEASE WEAR APPROPRIATE
CLOTHING, GLOVES, EYE PROTECTION AND
OTHER SAFETY EQUIPMENT RECOMMENDED BY
THE CUTTING TOOL MANUFACTURER.
ClipStone installation requires two points of attachment
per piece for fastening to the substrate.
If this cannot be done, use Loctite PL Construction
Adhesive to adhere stone surfaces together where there
is a difcult area for attachment (i.e. under a soft)
Fig. 5
FOR INTERIOR WALL PREPARATION (see Fig. 5)
• ClipStone is intended for installation over 7/16 inch minimum plywood or OSB.
DO NOT INSTALL CLIPSTONE DIRECTLY TO DRYWALL.
• Install minimum 7/16 inch or greater OSB or plywood substrate to wood studs to act as
substrate for ClipStone installation.
• If any questions as to the structural integrity of the sheathing or framing, contact a qualied
contractor or building inspector.
• Insure plywood is attached to the structural studs behind the drywall in accordance with local and national codes.
• For interior applications, Water Resistive Barrier or housewrap is not required.