Technical Specifications

SPECIFICATION GUIDELINE
SECTION 04700 - Simulated masonry
(Manufactured stone veneer and
t r i m )
1.3 REFERENCES (con’d)
RILEM 11.4 – Measurement of Water Absorption Under Low Pressure.
UL 723 – Standard for Safety for Surface Burning Characteristics of Building Materials.
A Building Code Compliance:
1. The International Association of Plumbing and Mechanical Officials (IAPMO)
B. Masonry Veneer Manufacturers Association (MVMA)
1.4 SUBMITTALS
A. Submit under provisions of section 01300.
B. Product Data: For each type of product indicated.
C. Shop Drawings: Indicate layout, show profiles and product components, including anchorage, accessories, finish
colors, patterns, and textures.
D. Qualification Data: ClipStone manufacturing and installing qualifications, safety and quality documents.
E. Test Reports: Certified test reports showing compliance with specified performance requirements and
physical properties.
F. Samples: Two complete sets of color cards representing manufacturer’s full range of available colors and styles.
G. Manufacturer’s Instructions: ClipStone Installation Procedures.
H. Certificates: IAPMO - ER-383.
I. Minutes of pre-installation conference.
J. Maintenance Data: ClipStone Installation Procedures.
K. Warranty: ClipStone product and installation warranties.
1.5 QUALITY ASSURANCE
A. IAMPO Certification: Environmental StoneWorks current IAMPO report - ER-383, which
include AC-51 testing data.
B. Single Source Responsibility: Obtain primary manufactured stone veneer and trim from a single manufacturer
with not less than five years of successful experience in manufacturing mortarless stone veneer products and
four years of successful experience in installing principal materials described in this section. Manufacturer
and Installer shall have completed at least ten projects of similar size and complexity. Provide secondary
materials only of type and from source recommended by manufacturer of primary materials.