Technical information

TECHNICAL INFORMATION
199
Learn
Use
Learn
Use
Use
C-Bus Wireless Quick Start Guide
Programming Your Remote Control
(getting the buttons on your remote control to turn your lights on and o)
Quick Tips
• To program other remote buttons at the same time, simply repeat steps 3 to 5 before performing steps 6 and 7.
• If you want to reassign a remote button that you have used previously, you must rst clear it by doing steps 1 to 2 above, then press the remote button you wish to clear, then do
quick double press on any button on the switch.
• The “scene” button on the remote allows each remote button to perform a second function. To program the second function, simply press the “Scene” button so that two light bulbs
appear in the remote’s blue display immediately before performing step 3 above.
Press & hold top two buttons
on any switch for 10 sec
until they ash alternately.
Remove the remote back
cover and slide switch to
the “learn” position.
Press the button on
the remote you want
to control your light.
Press the button on the
switch that you want to
control with your remote.
Wait until switches return
to learn mode and buttons
ash alternately.
Press & hold top two
buttons for 1 sec.
Slide switch to “use” mode
and replace back cover.
You’re done!
S T E P 1 S T E P 2 S T E P 3 S T E P 4 S T E P 5 S T E P 6 S T E P 7