Technical information

TECHNICAL INFORMATION
198
Learn
Use
Learn
Use
Use
Learn
Use
Learn
Use
Use
Learn
Use
Learn
Use
Use
Creating Scenes (dimming and turning several lights on or o with the press of one button)
C-Bus Wireless Quick Start Guide
IMPORTANT: Before you can create scenes you must:
Part 1: Create a Scene Button as per below
Part 2: Ensure that any buttons that will be included in your scene have either been used in a “group” as per above “Grouping Buttons” section
OR “grouped to itself” as per Step 2 below. This is because buttons require an individual “ID” number to be included in a scene which is
only given to a button when it is used in a group or grouped to itself.
Quick Tips
• If a light you have included in your scene does not turn on it may mean it has not been “grouped” - see “Important, Part 2” section above.
• To create an “all o” button for when you go to bed or leave the house, put the scene key into learn mode, then go around your house
and turn every light on then o, then exit scene learn mode. The scene button will now turn every light o in your home with one press.
• Why not create an “all on” scene in your bedroom as an emergency panic button.
• Another great idea is a dimly lit scene in your hallway for when you get up at night to check on the kids.
Part 1 - Create your Scene Button
Creating the button you want to control your scene.
Part 2 - Grouping a Button to “itself”
Creating an ID number - if button has not been included in group.
Part 3 - Create your Scene
Now that you have created your scene button and made sure all of your buttons have their own ID number - it’s time to create your scene.
Press & hold top two
buttons for 10 sec until
they ash alternately.
Double quick-press
the button you want
to control your scene.
Press & hold top
two buttons for 1 sec.
You’re done!
S T E P 1 S T E P 2 S T E P 3
Press & hold top two
buttons for 10 sec until
they ash alternately.
Press the button you
want to “group to itself”.
Press & hold top
two buttons for 1 sec.
You’re done!
S T E P 1 S T E P 2 S T E P 3
Press & hold the scene
button for 10 sec until
it ashes (entering Scene
Learn Mode).
Turn on any lights to the
desired level for your scene.
This may include plug
adaptors with lamps.
Press the scene
button for 2 sec
(exit Scene Learn Mode).
You’re done!
S T E P 1 S T E P 2 S T E P 3