Technical information
TECHNICAL INFORMATION
197
C-Bus Wireless Quick Start Guide
Creating Your Network (getting your units to talk to each other)
Quick Tips
• When a switch is put into learn mode the buttons will ash rapidly for approx 5 sec - this is normal.
It is best to wait for them to ash slowly before performing your next task unless specied (such as step 3 above).
• You can network more than one switch at a time - repeat steps 2 and 3 on following switches before performing steps 4 to 6
• Network a plug adaptor exactly the same way as a switch - the buttons are just vertical instead of horizontal.
• Once all of your switches are networked they will all automatically go into learn mode the next time it is entered on one of the switches.
• It is best to network all of your switches and plug adaptors before moving on to grouping buttons and creating scenes.
Grouping Buttons (getting a button on one or more switches to turn on a light on another switch)
IMPORTANT: If your switch controls two separate lights, you MUST enter learn mode using the two buttons that are connected to the light you wish to control.
Quick Tips
• You can turn on a light from several switches - repeat step 3 on other buttons you would like to operate the light before performing step 4.
• If the grouped buttons ash after performing step 3, it means you have held the button too long and it has become a timer.
If this happens, simply press it twice. This will unnasign the button as a timer it, and reassign it as a group.
• If learn mode is entered on a switch whose lights have been used in a group, those buttons will become illuminated after a few seconds instead of ashing alternately.
Press & hold top two buttons
on rst switch for 10 sec
until they ash alternately
(entering Learn Mode).
Press top two buttons on
next switch for 10 sec until
they ash alternately
(entering Learn Mode).
Press top two buttons
again while they are still
ashing rapidly (within
approx 5 sec).
Press & hold top left
button and do two quick
presses to top right button.
Lights will ash rapidly
for several seconds.
Wait until switches
returns to learn mode
and buttons ash
alternately.
Press & hold top
two buttons on either
switch for 1 sec
(exit Learn Mode).
You’re done!
S T E P 1 S T E P 2 S T E P 3 S T E P 5 S T E P 6
Press & hold the two buttons that are
connected to the light you want to operate
for 10 sec until they ash alternately.
Press the button that
controls the light you want
to operate. That light
should now turn on.
Press the button(s) on
other switch(es) that you
want to control the light
you have turned on.
Press & hold top two
buttons on either switch
for 1 sec.
You’re done!
S T E P 2 S T E P 3 S T E P 4
Learn
Use
Learn
Use
Use
Learn
Use
Learn
Use
Use
S T E P 4
S T E P 1
OR