Specifications

C-Bus Wireless Gateway (433.92 MHz) Installation Instructions
LEAR
N
button
5800WCGA
C-Bus Wireless Gateway
C-Bus Supply: 15-36Vdc, 32mA
RF Frequency: 433.92MHz
Patent Pending
This unit must be
used with CLIPSAL C-Bus system
only.
WARNING:
LEARN
Made in Australia
C-Bus
Network
Address
C-Bus
Network
Address
Figure 3 — The LEARN button is on the base of the Gateway
4.2 Connecting to a Wired Network
To connect the Gateway to a C-Bus wired Cat-5 network:
1) Plug the Gateway into the wired C-Bus network as described in
section 3.2.
2) Use the C-Bus Toolkit software to configure the wired side of the
Gateway. Note the following points,
• The Unit Address of the wired near side of the Gateway
(GATEWLSN) must match the Network Address of the C-Bus
Wireless network being linked to.
• The Unit Address of the wireless far side of the Gateway
(WGATE5F) must match the Network Address of the C-Bus
wired network being linked to.
• After using the “Scan Network” function in the Project Manager
“Units” view, the Gateway appears as a unit on the wired C-Bus
network. You can select the Gateway in this view and use the
“Make Network” function, to create and open the connected
C-Bus Wireless network.
8