Specifications

C-Bus Wireless Gateway (433.92 MHz) Installation Instructions
4.0 Configuration and Programming
Before the Gateway can be used, it needs to be connected to a wireless
and wired C-Bus network. The connection to a wireless network is
accomplished by a learn operation. The connection to a wired network
requires the use of the C-Bus Toolkit software.
4.1 Connecting to a Wireless Network
These steps are illustrated in Figure 2. To link the Gateway to a C-Bus
Wireless network:
1) Select a C-Bus Wireless wall switch or plug adapter on the network
you want to link to.
2) Press and hold the top two buttons for 10 seconds (until the unit’s
indicator lights start flashing alternately). This activates learn
mode on the wireless network.
3) Press the LEARN button on the base of the Gateway (shown in
). An indicator light at the front of the Gateway starts
flashing slowly. You must complete step 4 within 3 minutes of
pressing the LEARN button.
Figure 3
4) Go back to the unit to be linked to. Hold down the left topmost
button and, while continuing to hold, quickly double-press the
right topmost button.
5) The slow flashing indicator light on the Gateway will flash quickly
for about one second, and then turn off. This confirms that the
Gateway has been linked to the C-Bus Wireless network. Press and
hold the top two buttons on the wall switch or plug adapter for
1 second, to exit learn mode.
Unit on network
to be linked to
10 second press Quick press Hold left button
Double-press right
Ste
p
1Ste
p
2Ste
p
3Ste
p
4
LEARN
Figure 2 — Connecting the Gateway to a wireless network
7