Specifications

C-Bus Wireless Gateway (433.92 MHz) Installation Instructions
3.0 Installation Procedure
It is important to select the right location to install a C-Bus Wireless
Gateway. Some considerations are listed below:
• There is a LEARN button on the base of the Gateway. This needs
to be accessible during setup, so that the unit can be connected to
the wireless network.
• The unit should be located centrally to other C-Bus Wireless units
so that all units are within range of each other.
• Choose a location free of water, humidity, direct sunlight and
heavy dust.
• Allow adequate ventilation.
• Do not cover the unit.
• The C-Bus Wireless Gateway is designed for indoor use only.
no wet
hands
no cleaner
spray
no
coverage
no direct
sunshin
e
no
dust
3.1 Mounting Instructions
The C-Bus Wireless Gateway can be placed horizontally on a convenient
surface. Adhesive feet are provided for attachment to the base of the unit.
Alternatively, the Gateway can be mounted on a wall using the keyhole
cut-outs located on the base of the unit. These have 40 mm fixing centres.
If wall mounting, ensure the unit can be removed easily, to allow access to
the LEARN button on its base.
3.2 Wiring Instructions
Plug a C-Bus Cat-5 cable connected to the wired C-Bus network into either
of the RJ45 sockets at the rear/top of the Gateway. The RJ45 sockets are
connected in parallel. Power is provided to the unit by the wired C-Bus
network.
6