C-Bus Wireless Gateway (433.
© Copyright Clipsal Integrated Systems Pty Ltd 2004–2008. All rights reserved. This material is copyright under Australian and international laws. Except as permitted under the relevant law, no part of this work may be reproduced by any process without prior written permission of and acknowledgement to Clipsal Australia Pty Ltd. Clipsal and C-Bus are registered trademarks of Clipsal Australia Pty Ltd. Schedule Plus and HomeGate are trademarks of Clipsal Australia Pty Ltd.
C-Bus Wireless Gateway (433.92 MHz) Installation Instructions Contents 1.0 2.0 3.0 4.0 5.0 6.0 7.0 8.0 Important Note Description Installation Procedure 3.1 Mounting Instructions 3.2 Wiring Instructions Configuration and Programming 4.1 Connecting to a Wireless Network 4.2 Connecting to a Wired Network 4.3 Gateway Identification 4.4 Communication Options 4.
C-Bus Wireless Gateway (433.
C-Bus Wireless Gateway (433.92 MHz) 1.0 Installation Instructions Important Note The use of any software not provided by Clipsal Integrated Systems (CIS) in conjunction with the installation of this product may void any warranties applicable to the hardware. 2.0 Description The C-Bus Wireless Gateway is used to link a single C-Bus wireless network to a single C-Bus Cat-5 wired network. It is functionally equivalent to a C-Bus bridge.
C-Bus Wireless Gateway (433.92 MHz) 3.0 Installation Instructions Installation Procedure It is important to select the right location to install a C-Bus Wireless Gateway. Some considerations are listed below: • There is a LEARN button on the base of the Gateway. This needs to be accessible during setup, so that the unit can be connected to the wireless network. • The unit should be located centrally to other C-Bus Wireless units so that all units are within range of each other.
C-Bus Wireless Gateway (433.92 MHz) 4.0 Installation Instructions Configuration and Programming Before the Gateway can be used, it needs to be connected to a wireless and wired C-Bus network. The connection to a wireless network is accomplished by a learn operation. The connection to a wired network requires the use of the C-Bus Toolkit software. 4.1 Connecting to a Wireless Network These steps are illustrated in Figure 2.
C-Bus Wireless Gateway (433.92 MHz) Installation Instructions 5800WCGA C-Bus Wireless Gateway C-Bus Supply: 15-36Vdc, 32mA RF Frequency: 433.92MHz Patent Pending WARNING: This unit must be used with CLIPSAL C-Bus system only. C-Bus Network Address C-Bus Network Address LEARN button LEARN Made in Australia Figure 3 — The LEARN button is on the base of the Gateway 4.
C-Bus Wireless Gateway (433.92 MHz) Installation Instructions A current version of C-Bus Toolkit software may be downloaded from www.clipsal.com (the Clipsal Integrated Systems web site). It is recommended that programming by software be performed by trained C-Bus installers. 4.3 Gateway Identification A Gateway is a form of C-Bus bridge which links wired and wireless C-Bus networks. Bridges and Gateways consist of two separate internal subunits, one for each network connection.
C-Bus Wireless Gateway (433.92 MHz) 4.4 Installation Instructions Communication Options The Gateway supports explicit routing of messages into and through both wired and wireless networks. Such messages are used by control software such as C-Bus Toolkit and control devices such as the C-Touch Colour Touch Screen. Several options are available when using C-Bus Toolkit software to edit the Gateway unit. The following options are included on the “Connection” tab: • • • 4.
C-Bus Wireless Gateway (433.92 MHz) Installation Instructions After powering up, the Gateway may take up to 1 minute to obtain a complete view of the wireless network. Under some circumstances, the Gateway can take 30 to 60 seconds to recognise that a unit has been added to or removed from a wireless network. When using C-Bus Toolkit software to view units on a wireless network, an ‘Update’ button is provided to cause the Gateway to rediscover all wireless units. 5.
C-Bus Wireless Gateway (433.92 MHz) 6.0 Installation Instructions Mechanical Specifications Parameter Description Dimensions (W×H×D) 105 × 149 × 26 mm Weight 105 g Fixing centres 40 mm 105.0 mm 149.0 mm 26.
C-Bus Wireless Gateway (433.92 MHz) 7.
C-Bus Wireless Gateway (433.92 MHz) 8.0 Installation Instructions Warranty The C-Bus Wireless Gateway product carries a two-year warranty against manufacturing.
C-Bus Wireless Gateway (433.92 MHz) Installation Instructions This page is intentionally left blank.
Technical Support and Troubleshooting For further assistance in using this product, consult your nearest Clipsal Integrated Systems (CIS) Sales Representative or Technical Support Officer. Technical Support Contact Numbers Australia 1300 722 247 (CIS Technical Support Hotline) New Zealand 0800 888 219 (CIS Technical Support Hotline) Northern Asia +852 2484 4157 (Clipsal Hong Kong) South Africa 011 314 5200 (C-Bus Technical Support) Southern Asia +603 7665 3555 Ext.
