Technical information

Clipsal Product Catalogue
74
S2000 Universal Tactile Dimmers
RedRedUnswitched Live
White White
Tactile / Bell Press Switch D/B Neutral
Additional Tactile / Bell Press Switch for “Two way
switching”
Dimmer
This new range of Dimmer Modules represents a revolution in
dimming technology.
For the installer, they are ideal, as they are suitable for use with
Leading and Trailing edge, Electronic or Wirewound Transformers.
These Dimmer Modules also have built-in short circuit and overload
protection.
For the end-user, the ‘scene’ programming facility transforms the
dimmer into an automated mood-setting control unit. A simple press
of the switch will set the lighting to pre-programmed levels, so there’s
no ddling to get the right level.
Set the fade time between settings and for switch o, and you’ve got
dimming that is convenient and easy to use.
Technical Information
1. Load
500W (2.1 amp), 800W (3.3 amp) – 12V low voltage or
230V up to maximum rating of the unit.
Can be used with Clipsal’s Scenemaster Fluorescent
Interface (E2400AM) to dim 1-10VDC Fluorescent
ballasts.
Contact your Clipsal rep for more information.
2. Wiring Instructions
3. Important
• Wiringmustbedonebyaqualiedelectricianin
compliance with the local code of practice.
• Thesedimmersareforinternaluseonly.
• Threeyearcarry-indistributorwarranty.
4. Trailing vs Leading Edge
The Leading Edge dimmer unit can be activated to a
Trailing Edge dimmer unit.
• Oncetheunitisinstalled,switchthemainpower
supply o.
• Presstheswitchandholddown.
• Switchthepowerbackonwhilststillholdingthe
switch down.
• Releasetheswitch.
All loads are Leading Edge, unless specied by•
supplier
5. Switch Operation
These dimmers are for use with a Tactile / Bell press
switch.
• Presstheswitchoncetoturnallthelightsonoro.
• Pressandholdtheswitchtodimdowntothe
required level.
• Releasetheswitchatthedesiredlevel.
• Presstheswitchagaintobrightenalllights.
• Pre-SetFactorySettings
• Pressswitch2timestodimto75%;3timesfor50%;
4 times for 30% and 5 times for 10%.
Dimmer