User guide

C
-
Bus OPC installation
User Guide
22
© Schneider Electric 2011
Typical error condition names and their active and inactive states
The table below lists the inactive and active state messages for each of
the error conditions.
List of error conditions and their messages
Error condition
names
Inactive state
messages
Active state
messages
Ballast Failure Ballast OK Ballast failure
Lamp Failure Lamp OK Lamp failure
Lamp Power Lamp OFF Lamp ON
No Command Received Command received
since power on
No command received
since power ON
Ballast Not Responding Ballast responding Ballast not responding
Channel Not Powered Channel powered Channel not powered
Over Temperature Temperature OK Over temperature
Over Current Current OK Over current
Control Communication
Error
Control
communication OK
Control
communication error
Status Communication
Error
Status communication
OK
Status communication
error
Ballast Controller
Failure
Ballast controller OK Ballast controller
failure
No Hardware Hardware present No hardware