Specifications

C-Bus Network Interface Installation Instructions
Using Telnet to Configure the CNI
In the instructions below, substitute cni_ip_addr for the temporary IP
address you are using with the CNI.
1) Type the following from a command prompt/terminal session, then
press Enter:
telnet cni_ip_addr 1
You should get a response something like "Could not connect to
host" or "Connection refused".
2) Type the following, then press Enter:
telnet cni_ip_addr 9999
You should get a response from the "Lantronix Universal Device
Server", and be prompted to "Press Enter to go into Setup Mode".
3) Press Enter within 5 seconds of the response (before the connection
times out).
The Change Setup menu will be displayed.
4) Use this menu and follow the prompts to configure the CNI. Typically,
press 0 for Server Configuration, then enter the permanent IP address
you want to set the CNI to. When prompted to enter the netmask
number of bits, refer to . In most cases you can choose 0 for
default. Once you have configured the settings, you must choose
option 9 "Save and exit", in order for the changes to be applied.
Table 4
Netmask Bits Netmask Bits Netmask Bits
Default 0 255.255.254.0 9 255.254.0.0 17
255.255.255.252 2 255.255.252.0 10 255.252.0.0 18
255.255.255.248 3 255.255.248.0 11 255.248.0.0 19
255.255.255.240 4 255.255.240.0 12 255.240.0.0 20
255.255.255.224 5 255.255.224.0 13 255.224.0.0 21
255.255.255.192 6 255.255.192.0 14 255.192.0.0 22
255.255.255.128 7 255.255.128.0 15 255.128.0.0 23
255.255.255.0 8 255.255.0.0 16 255.0.0.0 24
Table 4 — Netmask number of bits
13