Instruction manual

1250SM0905R10/09 C-Bus™ Networking
10/2009
C-Bu
s Prod
uct
s
Traini
ng C
our
se
PLEASE NOTE
Electrical equipment should be installed, operated, serviced, and maintained only by
qualified personnel. This document is not intended as an instruction manual for untrained
persons. No responsibility is assumed by Square D for any consequences arising out of
the use of this manual.
CLASS B FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
© 2009 Schneider Electric. All Rights Reserved.