Specifications

19 of 36

50x0CTC3 Series C-Touch Colour Touch Screen Installation Instructions

5.0 C-Bus Programming Requirements

Unit Address

The touch screen must be programmed with a unique identication address (unit

address). This is accomplished using C-Bus Toolkit software, available from the

Downloads section of the Clipsal Integrated Systems (CIS) web site at:

http://www.clipsal.com/cis.

System Clock and Burden

C-Bus Toolkit is also used to enable the system clock and burden, if required.

The unit incorporates a software selectable C-Bus system clock that is used for

synchronizing data commmunications on the network. A maximum of three enabled

system clocks should exist on a network, so the system clock on the touch screen is

disabled by default.

Colour Touch Screen Project

The touch screen must be conﬁgured for a particular C-Bus installation with

a project that has been produced using the Programming Interface for C-Bus

Embedded Devices (PICED) software. PICED software is available from the

Downloads section of the CIS web site. Documentation and Help ﬁles are included

with the software.

After you have produced a project, select the ‘Transfer Project To C-Touch Colour’

option located in the Transfer drop down menu. The C-Touch Colour Transfer Utility

software sends the project to the unit via the Ethernet LAN. The utility is included

with PICED software and allows you to perform various conﬁguration functions,

such as setting the time.

The installer should make copies of the Toolkit and PICED project ﬁles and also

give a copy to the customer.