Specifications

10 of 36

50x0CTC3 Series C-Touch Colour Touch Screen Installation Instructions

5. Place the side clamps so that they clamp the bracket to the plasterboard and

then tighten the side clamp screws.

6. Connect the cables to the back of the touchscreen. Refer to the wiring

instructions.

7. Carefully place the touch screen in the bracket and use the four long screws to

fasten the unit in place.

Nail Bracket

The C-Touch Colour Nail Bracket, catalogue number 5000CTCNA, is used where it

is practical to nail or screw the bracket to a wall frame.

Figure 7. Nail Bracket

To mount the touch screen using the nail bracket do the following:

1. Prior to cladding the wall, use nails or screws to ﬁrmly attach the nail bracket to

the wall frame.

2. Feed the cables through the nail bracket. Refer to Figure 8. The use of

conduit is recommended. The positioning of cables will vary depending on the

installation.

After the wall cladding is installed, perform steps 3 and 4.

3. Hold the touch screen up to the bracket and connect the cables. Refer to wiring

instructions in this document.

4. Place the unit in the bracket and use the four screws provided to fasten the unit

in place. Do not overtighten the screws.