User`s guide

Intelligent Building Series C-Touch User’s Guide

8.0 New Features in Firmware 1.8

The Firmware 1.8 release contains a number of enhancements to C-Touch functionally.

These include:

• Editing of scene levels within the C-Touch unit

• Editing of schedule start times within the C-Touch unit

• A new diagnostics page

• An improved backlight page

8.1 Scene Editing

If a scene is activated by a button on a page (see Section 10) then the

underlying scene can be edited by pressing the button for 6 seconds and then

releasing it. (The screen issues a beep when it is time to release the button) The

Scene Programming screen is shown below:

The “Reset Levels” button resets the current scene as originally designed.

Pressing the “Store Levels” button will store the current levels (which may be set

by any means, such as walking around and setting levels by eye). The “Adjust

Levels” button allows manual adjustment of the levels in the scene. Pressing this

button will produce this screen:

Each load in the scene is accorded a slider with a label showing its group

address in Hexadecimal. If more loads are included in the scene than can be

accommodated on the screen then the upper right hand corner will show a “next”

button to see the rest of the loads.