Specifications
Intelligent Building Series C-Touch Programming Reference
If the component is a button, the state of the button will change (if C-Bus is
connected, the command will be executed).
A more complete simulation mode can also be set by selecting the item
from the Options | Simulation Mode, or by pressing CTRL + S. The key
combination CTRL + S is used to get out of Simulation Mode since the
menus are hidden in simulation mode.
Simulation mode does the following things:
• Components are activated by a left or right mouse click
• Passwords operate (although the appearance of the dialogue differs
from that on the actual C-Touch unit)
• The menus and tool bars are hidden.
7.9.4 Logging
The C-Touch software offers the ability to log the commands being sent
over a connected C-Bus network. This can be extremely useful for
debugging a project. The logging screen is activated by selecting Options
| Show Log … . Here is a screen shot of the logging screen:
As may be seen from this illustration, the log file can be enabled or
disabled as required and the results can be saved to a file or appended to
an existing log file.
© Copyright 2002 Clipsal Integrated Systems Pty Ltd Page 48