Specifications

Intelligent Building Series C-Touch Programming Reference

Triggering

A particular Group Address and Level may be used to trigger a scene. The

triggering Group Address and level are entered in the Scene Editor by

selection from the proffered options. If the Scene does not need to be

triggered from a remote unit, this is left as “unused”. Typically, a particular

Group Address on the Enable Application (number CB hex) will enable the

Schedule when it is at 100%.

Note: A group address needs to be set to the relevant

trigger level, it is not sufficient to ramp through it.

Actions

The actions are the C-Bus events that the Scene will execute.

A new action is added with the Add button. At the bottom of the dialogue

box, the desired Group, Level and Ramp Rate are entered.

An alternative method of setting the level is to adjust the brightness of a

dimmed globe by eye for a particular visual effect manually. Once set, the

To Current Level radio button is used to store the setting in the action

being programmed. (Naturally, the computer running the C-Touch

configuration software must be connected to the network in question for

this to work).

Another action may be added, by entering new values and selecting the

es button again.

An action is deleted by selecting the required action from the list and

clicking on the Delete button.

An action is edited by selecting the required action from the list and

clicking on the Edit button. Alternatively it is possible to simply double click

the item in the list.

The order in which actions occur may be changed by selecting the

required one from the list and clicking on the Up or Down buttons until it is

in the correct position.

All changes are completed by clicking on the OK button. Clicking on the

Cancel will exit without making changes to the Scene.