Specifications

Intelligent Building Series C-Touch Programming Reference

To match the size of several components, the component that the others

must match is selected (this is called the “Primary Selection”). Then the

other component(s) are selected. The height, width or both can be set by

either clicking the “Size” speed buttons on the tool bar or selecting

Edit | Size and choosing one of Height, Width or Both.

Some components have a minimum size. If the size is

set too small, it will be automatically adjusted to that

minimum. Some components have a fixed size, and

cannot be ad

usted.

7.5.7 Alignment

Components are drawn on the page where they

are placed. Sometime it is desirable to move one

or more components so that they line up with

each other or with the page outline. To change the component alignment:

• Select the component(s) which you want to change

• Either select E

dit | Align Select the required alignment(s) which can

be made in several ways:

• Secondary selections can be aligned with respect to the primary

selection

• Components may be aligned to the center of the page

• A group of components may be aligned to the center of the page

• Components can be spaced evenly

• Click on OK.

• Or click on one of the Align speed buttons on the tool bar (shown

below.)

If the Align to Grid checkbox is selected, all of the selected components

will be placed on the grid.

7.5.8 Drawing Order

Components are drawn on the page in the

order in which they are placed. Sometime it is

desirable to change the order so that a

particular component will be drawn behind

another one, for example. To change the order in which components are

drawn:

• Select the component which is to change

• Either select the E

dit | Component Order menu from the menu and

select from the following actions:

• Move Back

• Move to Back

• Move Forward

• Move to Front

• or use one of the toolbar buttons (shown below.)