Specifications

Intelligent Building Series C-Touch Programming Reference

7.4.4 C-Bus Properties

To change the C-Bus Properties of a particular Component, either:

• Double click on the component, or

• Select the component (by clicking on it) and select the

dit | Component Properties menu item

• Select the C-Bus tab.

To set the C-Bus properties:

• Select the C-Bus type (see below)

• Enter the Application Number

• Enter the Group Address

• Select any other properties required for the C-Bus type

The component will behave differently depending on which type is

selected. The C-Bus component can be set to any of the following types:

• ON: this switches the load on.

• OFF: this switches the load off.

• ON/OFF: this toggles the load on and off. If the load level is greater

than 0%, it is regarded as being on.

• DIMMER: a short press will toggle the load on and off. A longer press

will dim the load up and down.

• ON/UP: a short press will switch the load on. A longer press will dim

the load up.

• OFF/DOWN: a short press will switch the load off. A longer press will

dim the load down.

• TIMER: this will switch a load to a particular level for a particular

time. When the time expires, the load will return to a specified level.

• PRESET: this will set the load to a preset level (0-100%).

• PRESS: this will set the load to a particular level while the

component is being pressed. When the component is released, the

load will return to a specified level.

• SCENE: This will set a scene.

• STATUS: this will show the C-Bus status, but pressing the

component will have no effect.

• UNUSED: this will not show C-Bus status nor perform any C-Bus

action when pressed.