Specifications

Intelligent Building Series C-Touch Programming Reference

The remote tab for the component, as shown, can be used to set the

properties of the component:

An association between a Component and a remote control key is set in

the following way:

• Display the properties of the component by double clicking on it

• Select the Remote Control tab from the Component Properties

dialogue box

• Select the IR Remote Control Enabled check box.

• If the remote control that came with the C-Touch unit is being used,

the desired key can be selected from the drop-down list which

contains an entry for each key

• If another remote control unit is being used, the Manufacturer and

Key codes will need to entered (see below).

Remote control codes can be found on various web sites, or can be read

via the C-Touch unit. The C-Touch unit will have to have a project loaded

which can access the Diagnostics page. The Unit Data page is then

selected, and information about the last received IR code may be read

from the page.

When the remote control is pointed at the C-Touch unit and a remote

control key pressed, the code for that press will appear on the C-Touch

display in the “IR Data Code :” field. This information from the C-Touch

unit can be used to record which key produces which keycode as

understood by the C-Touch unit. These codes can then be used in

programming the project.

In the specific case where the C-Touch remote is being used, the remote

control codes that have been set up can be tested to show that the project

is configured correctly.