Specifications

Intelligent Building Series C-Touch Programming Reference

Monitor Tab

A monitor component is like a gauge that can display the value of some

variable. A monitor can be used to display temperature, light levels or

voltage. A temperature component properties tab is illustrated below:

Since a C-Bus unit must furnish these values, the unit address of the unit,

between 00 and FE must be supplied. The readings displayed can be

updated at different intervals. The time between updates of the display

may range from 20 to 255 seconds. A short refresh interval would load the

C-Bus network with commands to a greater extent than a long interval.

Unless the information has to be very current the longer times should be

used.

Finally, the number of decimal places from zero to two [0..2] may be

specified.